Round Votive Mould

Round Votive Mould

Icicles Mould

Icicles Mould

Rainforest Leaf Mould

£53.50 £44.58
1 in stock
Rainforest Leaf Mould for glass

Create texture and interest in your work with this versatile mould. Use with naturalistic or vibrant frit colours to create different effects.

Fill Weight: 120-130g glass frit.

When filling the mould, pile the frit in a pyramid or dome shape so the centre of the mould is filled higher than the edges. This helps the correct flow of glass during firing, lowering the risk of the glass 'grabbing' the mould sides as it fires:

Filling a glass casting mould

The mould is 22.5cm x 15cm x 4cm. It creates a cast glass leaf of approximately 20cm across.

Use the built in slumper on the mould’s reverse side to curve the leaf into a dessert plate or similar.  See the example below and the pdf tip sheets for inspiration:

We strongly recommend using ZYP Boron Nitride Spray with our casting moulds for the very best results. Primo Primer can also be used. Standard shelf primer is not suitable.

Will this mould fit in my glass kiln?

Please note that all our moulds are hand-made and therefore the dimensions may vary slightly from those shown. Mould manufacturers allow a tolerance of up to 2cm. We strongly recommend cutting the glass to the size measured from the actual mould rather than relying solely on the dimensions shown.

All our moulds are designed for multiple use and with care should last for many firings.

Write Your Own Review
You're reviewing:Rainforest Leaf Mould
Your Rating
Customer Questions
No Questions
Did you find what you were looking for?
We found other products you might like!