One mould produces two dragonfly sizes: 3” and 4”. On the mould’s reverse side is an integrated wing slumper to make your dragonflies lifelike.
Fill weight: 36 grams and 50 grams. Dimensions are 3” and 4”.
When filling the mould, pile the frit in a pyramid or dome shape so the centre of the mould is filled higher than the edges. This helps the correct flow of glass during firing, lowering the risk of the glass 'grabbing' the mould sides as it fires:
We strongly recommend using ZYP Boron Nitride Spray with our casting moulds for the very best results. Primo Primer can also be used. Standard shelf primer is not suitable.
Suggested firing schedule when using Bullseye frit:
Segment | Rate (C/Hr) | Temp (C) | Hold Time |
1 | 165 | 735 | 10 mins |
2 | 999 (AFAP) | 482 | 60 mins |
Outer dimensions: 215mm x 128mm (approx.). Made by Colour de Verre.
Please note that all our moulds are hand-made and therefore the dimensions may vary slightly from those shown. Mould manufacturers allow a tolerance of up to 2cm.
All our moulds are designed for multiple use and with care should last for many firings.