Create your own free-standing picture with this exciting stainless steel mould. This clever design ensures that your slumped glass will be able to stand freely after firing without the need for display stands, keeping all the focus on you glass project!
This mould works best with 3mm glass, simply place your glass over the mould and fire to a slump mould.
Primer should always be applied to the mould before slumping, we recommend Boron Nitride Spray with Stainless Steel Moulds.
Product dimensions: 12.5cm wide x 14cm length x 6cm depth (lip is 1.5cm)
Please note: Make sure to remove any protective film or stickers from the moulds before use.
Firing Schedule:
This firing recommendation has been calculated using Bullseye Glass with a thickness of 3mm.
Segment | Rate (C/hr) | Temp. | Hold |
1 | 167C | 649C | :20 |
2 | 999 | 482C | 1:00 |
3 | 56C | 371C | :00 |
Troubleshooting:
We recommend using our Boron Nitride Spray with this mould for an easy release.
Each mould may vary slightly due to the manufacturing process so we would always recommend cutting the glass to the size measured from the actual mould rather than relying solely on the dimensions shown.