Rimless Bowl Mould (22cm diameter x 3.2cm)
Rimless Bowl Mould (22cm diameter x 3.2cm) Rimless Bowl Mould (22cm diameter x 3.2cm) Rimless Bowl Mould (22cm diameter x 3.2cm)
Extra Large Drop Out Mould 8156 (34cm od, 20cm id)

Extra Large Drop Out Mould 8156 (34cm od, 20cm id)

Round Tray Mould 8460 (13.2cm diameter x 2cm)

Round Tray Mould 8460 (13.2cm diameter x 2cm)

Rimless Bowl Mould 8455 (22cm diameter x 3.2cm)

£44.75 £37.29
3 in stock
SKU
Z-G015
Rimless Bowl Mould 

Create beautifully rounded dishes using this mould.

All our moulds are designed for multiple use and with care should last for many firings.

A great simple dish to add to your range, this is a perfect addition to the Round Tray Moulds to create a stunning tableware set!

Inner Dimensions: Diameter: 22cm, Height 3.2cm
Outer Dimensions: Diameter: 22.7cm, Height 4cm
This mould fits in the Hotstart Pro kiln.

Bullseye Code: 8772

Please note that all our moulds are hand-made and therefore the dimensions may vary slightly from those shown. Mould manufacturers allow a tolerance of up to 2cm. We strongly recommend cutting the glass to the size measured from the actual mould rather than relying solely on the dimensions shown.

Will this mould fit in my glass kiln?

Firing Schedule:

Please Read: This firing recommendation has been calculated using Bullseye Glass with a thickness of 6 mm in a Paragon GL24 kiln, and is courtesy of Bullseye Glass Co. 

Segment Rate (C/hr) Temp. Hold
1 111C 660C :20
2 999 482C 1:00
3 56C 371C :00

Troubleshooting

  • Small kilns may require the process temperature reducing. In the Hobbyfuser and HotStart Pro, reduce the top temperature from 660C to 637C. In the Firebox 14, reduce the top temperature from 660C to 617C. All kilns vary, as does glass viscosity. Testing is necessary.

  • Remove the shelf when slumping in small kilns.

  • Side firing kilns may require more time in the first ramp than top firing kilns.

  • Bubbles in slumping are caused by firing too high or holding too long at process temperature.

  • Cracked moulds or cracked glass is caused by firing too fast in the first ramp or cooling too fast.

  • Devitrification on the outside of a slumped piece is caused by firing too high or holding too long at process temperature.

All our moulds are designed for multiple use and with care should last for many firings.

Write Your Own Review
You're reviewing:Rimless Bowl Mould 8455 (22cm diameter x 3.2cm)
Your Rating
Customer Questions
No Questions
Did you find what you were looking for?