Single Candle Bridge Mould 8303 (17.5cm x 12.3cm x 3.8cm)

Candle Bridge Mould  

Create chic, stylish candle holders with this convex slumping mould.

Inner Dimensions: Length: 17.5 cm, Width: 12.3 cm, 
Outer Dimensions: Length: 18.2 cm, Width: 13 cm, Height: 5 cm 
Opening Dimensions: 8cm x 8cm, Height: 1.5 cm

Bullseye Code: 8903

Please note that all our moulds are hand-made and therefore the dimensions may vary slightly from those shown. Mould manufacturers allow a tolerance of up to 2cm. We strongly recommend cutting the glass to the size measured from the actual mould rather than relying solely on the dimensions shown.

For a circular candle opening, try the Elegant Candle Holder mould. 

Firing Schedule:

Please Read: This firing recommendation has been calculated using Bullseye Glass with a thickness of 6 mm in a Paragon GL24 kiln, and is courtesy of Bullseye Glass Co. 

Troubleshooting

• Small kilns may require the process temperature reducing. All kilns vary, as does glass viscosity. Testing is necessary.

• Remove the shelf when slumping in small kilns.

• Side firing kilns may require more time in the first ramp than top firing kilns.

• Bubbles in slumping are caused by firing too high or holding too long at process temperature.

• Cracked moulds or cracked glass is caused by firing too fast in the first ramp or cooling too fast.

• Devitrification on the outside of a slumped piece is caused by firing too high or holding too long at process temperature.

• To prevent the glass pulling in at the edges when it slumps into the top of the mould, make sure your glass is slightly wider (no more than 5mm) than the edge of the mould. This will stop the glass pulling in at the sides.

All our moulds are designed for multiple use and with care should last for many firings.