Create lamps or curved objects which can stand upright on their own, using this semi-cylindrical mould.
Alternatively glue two identically slumped glass pieces together and add a base to create a deep vessel or vase.
Size: 35cm x 37cm, depth 11cm.
Bullseye Code: 8726
Width of glass needed to drape fully round the mould: 40cm
Please note: This mould does not fit in the Firebox 14 or HotStart Pro kiln. For a smaller version try the Small or Mini Lamp Bender moulds.
Firing Schedule:
Please Read: This firing recommendation has been calculated using Bullseye Glass with a thickness of 6 mm in a Paragon GL24 kiln.
Segment | Rate (C/hr) | Temp. | Hold |
1 | 167C | 649C | :20 |
2 | 999 | 482C | 1:00 |
3 | 56C | 371C | :00 |
Troubleshooting
Small kilns may require the process temperature reducing. In the Hobbyfuser reduce the top temperature from 649C to 626C. All kilns vary, as does glass viscosity. Testing is necessary.
Remove the shelf when slumping in small kilns.
Side firing kilns may require more time in the first ramp than top firing kilns.
Bubbles in slumping are caused by firing too high or holding too long at process temperature.
Cracked moulds or cracked glass is caused by firing too fast in the first ramp or cooling too fast.
Devitrification on the outside of a slumped piece is caused by firing too high or holding too long at process temperature.
Please note that all our moulds are hand-made and therefore the dimensions may vary slightly from those shown. Mould manufacturers allow a tolerance of up to 2cm. We strongly recommend cutting the glass to the size measured from the actual mould rather than relying solely on the dimensions shown.
All our moulds are designed for multiple use and with care should last for many firings.