Maple Leaves Mould with Slumper
Maple Leaves Mould with Slumper Maple Leaves Mould with Slumper
Slab Server Mould

Slab Server Mould

Teardrop Pendant Mould

Teardrop Pendant Mould

Maple Leaves Mould with Slumper

£44.50 £37.08
1 in stock

This mould creates two sizes of maple leaves which can be used to embellish larger glass pieces or used on their own as beautiful trinket dishes. Use the built-in slumper on the moulds reverse side to make the leaves really lifelike.

Check out the PDF downloads for tips on how to use this versatile mould.

We strongly recommend using ZYP Boron Nitride Spray with our casting moulds for the very best results. Primo Primer can also be used. Standard shelf primer is not suitable.

Finished Pieces: 7.6cm and 10cm

Fill Weight: 40g and 60g 

External Mould Dimensions: 23.5 x 12.5 x 3.5cm


When filling the mould, pile the frit in a pyramid or dome shape so the centre of the mould is filled higher than the edges. This helps the correct flow of glass during firing, lowering the risk of the glass 'grabbing' the mould sides as it fires.

Please note that all our moulds are hand-made and therefore the dimensions may vary slightly from those shown. Mould manufacturers allow a tolerance of up to 2cm. All our moulds are designed for multiple use and with care should last for many firings.

Write Your Own Review
You're reviewing:Maple Leaves Mould with Slumper
Your Rating
Customer Questions
No Questions
Did you find what you were looking for?
thincasting (503.73 kB)
MapleLeafBowls (503.73 kB)
AutumnLeafPlatter (503.73 kB)